Premier Wireless Sensors
Leak Detection
Avoid costly repairs. Receive alerts when water is detected in areas where appliances are present; such as water heaters, sinks, utility closets, and bathrooms.
Water Leak IP67
The Leak Detector can be placed near bathrooms, washing machines, and other appliances or fixtures and will keep an eye out for water leaks. It can detect as little as three drops of water. The Leak Detector will notify the user on sensing water and the Valve Controller (sold separately) will automatically shut off water to prevent further damage. Three separate set of sensors, the Bottom (Main) Sensors, the Drip Tray, and the Remote Sensor Probe (optional), act together to monitor any appliance or fixture for leaks.
Learn more
Water Leak Sensor
The Dragino LWL01 is a LoRaWAN Water Leak Sensor. It detects the water leak status and send it to LoRaWAN network. LWL01 is powered by a CR2032 coin battery, in a good LoRaWAN Network Coverage case, it can transmit as many as 12,000 uplink packets (base on SF7, 14dB). in poor LoRaWAN network coverage, it can transmit ~ 1,300 uplink packets (base on SF10, 18dB). The design goal for one battery is up to 2 years. User can easily change the CR2032 battery for reuse.
Learn more
Indoor Water Leak Sensor
The wireless water leak sensor uses a water probe to detect the presence of water or other liquids. When the presence of water or another liquid is detected, an alert is sent over the wireless network.
Learn more
Water Rope Leak Detector
Netvox’s wireless water leak detector with rope sensor detects the presence of water if any portion of the rope becomes wet. The status data is sent to the data centre via the LoRaWAN protocol at pre-programmed intervals in addition to the signal being sent when a leak is detected.
Learn more
Indoor Water Leak Sensor
Netvox R311W Is A Water Leak Sensor Based On LoRaWAN™ Protocol (ClassA) Carrying Leak Detection And Alarm Function. When Z311W Detects A Leak, It Will Send An Alarm Message To The Gateway. When The Sensor Detects No Leak, It Will Send A Message That Reports The Status To The Gateway. There Are Two Water Leak Sensors Which Allow Users To Monitor Two Spots
Learn more
enLink Status-L Leak Sensor
enLink Status-L detects the presence of water leaks, flooding and condensation using a water detection cable. Leakage or moisture is detected over the entire length of the cable, various cable lengths are available to facilitate leakage sensing over a wide area. When a leak is detected, a message is transmitted using long range LoRa wireless to generate an alarm so early action can be taken. (comes with 1 metre detection rope plus 0.5m leader)
Learn more
Water Rope (Enhanced)
The Netvox Water Rope can run up to 300m and uses a water detection wire to determine any if there any leaks present. The device sends the leak message within 10 seconds of detection.
Learn more
Get started today.
To learn more about our solutions, call (281) 667-0404, or request an online meeting.